I've been struggling to get it to work ..Mini Kossel + Repetier 0.91 firmware + Ramps 1.4 + FSR (3) + FSR Endstop Controller.
The printer has been running for months without FSRs. The motors are not skipping, the printer is calibrated and the print surface is close to level.
I verified that the FSR's are working correctly with G31 and can measure the distance with G30.
When I run a G29 on the three points this is what I see:
12:52:49.224 : Z-probe:5.00 X:0.00 Y:60.00 or any value I set as max z probe bed dist
12:52:50.458 : Z-probe:8.12 X:-50.00 Y:-27.00
12:52:52.223 : Z-probe:8.18 X:50.00 Y:-27.00
12:52:52.755 : Z-probe average height:7.1
the average height being calculated is skewed causing the nozzle to be 5 to 15 mm above the print surface
Any help or suggestions will be appreciated.
See Configuration.h below
Thanks
The printer has been running for months without FSRs. The motors are not skipping, the printer is calibrated and the print surface is close to level.
I verified that the FSR's are working correctly with G31 and can measure the distance with G30.
When I run a G29 on the three points this is what I see:
12:52:49.224 : Z-probe:5.00 X:0.00 Y:60.00 or any value I set as max z probe bed dist
12:52:50.458 : Z-probe:8.12 X:-50.00 Y:-27.00
12:52:52.223 : Z-probe:8.18 X:50.00 Y:-27.00
12:52:52.755 : Z-probe average height:7.1
the average height being calculated is skewed causing the nozzle to be 5 to 15 mm above the print surface
Any help or suggestions will be appreciated.
See Configuration.h below
Thanks