Hi,
just tried to install dev-version with the new TEMP_GAIN activated.
Result was, the Temperature-Reading for the Bed was always 0.0 Degrees and the Bed did not activate.
Looking in the Eeprom settings, there were new values for the extruder temp-gain and temp-bias but not for the bed.
Using a Radds board and the temp_1_pin for the heated_bed_sensor_pin.
The Extruder Temp Readings are okey.
Deactivated the temp_gain and compiled again = Bed works as it should.
just tried to install dev-version with the new TEMP_GAIN activated.
Result was, the Temperature-Reading for the Bed was always 0.0 Degrees and the Bed did not activate.
Looking in the Eeprom settings, there were new values for the extruder temp-gain and temp-bias but not for the bed.
Using a Radds board and the temp_1_pin for the heated_bed_sensor_pin.
The Extruder Temp Readings are okey.
Deactivated the temp_gain and compiled again = Bed works as it should.