Hi
I have build my own delta printer, and I am having problems understanding the dimensions in repetier configurator.
There is a picture under dimensions when you use the configuration web tool. On this picture a dimension is showed called 'printer radius'.
Is this 'printer radius' the same value I have to put into the field 'Max. horizontal radius'?
If this 'printer radius' on the picture is the same as 'Max horizontal radius', where do I then limit the print radius?, maybe the printbed don't have same radius as printer radius on the picture.
The Z length or Z_max_length, is that the nozzle height over the print bed when all sliders is at max. stop?
How about 'Floor safety margin', what to understand by that?
I am using a diamond 3 filament mixing hotend. I have printet out an effector I designed my self with capacitive proximity sensor holder, and the diamond head holder to fit the effector.
I noticed that my nozzle tip is not perfectly in the middle of the effector, even if all the dimensions on the printed parts seems ok.
I think it is because the diamond head holder is not perfectly designed.
Can I correct this error, nozzle tip not centered in effector, with the 'Radius error column A/B/C' ?
Thank you for all help you can give :-)