HI. I have repetier 0.92 since a while. No problems at all. Today O changed my Z threaded rods to lead screws. So I changed my Z steps in configuration.h. I uploaded the firmware useing the arduino software, I did a M500 command follewed by a M501 command. it went ok. No other changes in the file were made, just the Z steps. My past and actual Z related values are: Z max feed rate 1, homeing Z speed is 2, Z accel is 100, Z jerk is 0.3
The problem is that now the Z speed seems to be stuck at 2 whatever moement I try to do. Useing repetier host if I move the Z axis it moves really slow, I asume it is moveing at a speed of 2. Homeing also is slow, at a speed of 2. I have trid to change the max feed rate from the repetier host eprom tool, I tried with a value of max z feed rate of 4 and z homeing speed of 4. Then a M500 command and a M501 command (in that order) and still the speed of Z axis is stuck in 2.
What is hapenning here?
The problem is that now the Z speed seems to be stuck at 2 whatever moement I try to do. Useing repetier host if I move the Z axis it moves really slow, I asume it is moveing at a speed of 2. Homeing also is slow, at a speed of 2. I have trid to change the max feed rate from the repetier host eprom tool, I tried with a value of max z feed rate of 4 and z homeing speed of 4. Then a M500 command and a M501 command (in that order) and still the speed of Z axis is stuck in 2.
What is hapenning here?