This is probably something simple, but I'm pretty hungup on it.
I have an azteeg x3 pro, and I've been working on the firmware for a while, actually upgrading from an azteeg x3.
At some point something changed and I cannot figure out what.
When I home x and y the axis will move until the switch, trigger the endstop, and then move some 20 and 80mm respectively away from the endstop, and then the repetier host will call this position x0,y0.
This has caused a handful of crashes because my soft limits now are beyond the limits of the printer.
This did not used to be an issue, and I cant find what I may have changed.
any ideas?