Liebe Kollegen,
I have four fans in printer: one for extruder0, second for print cooling, third for motherboard, and last one is for enclosure ventilation (thermo coupled fan).
After the print with stinky ABS or whatever is finished I would like to ventilate the enclosure at full speed. I am trying to add a command M106 P0 S255 to the end of gcode but whichever fan number parameter I use (P0 or P1 or P2 or P3) they always turn on the print cooling fan. Is there a way to send this command to thermo-coupled fan?
Thank you.
I have four fans in printer: one for extruder0, second for print cooling, third for motherboard, and last one is for enclosure ventilation (thermo coupled fan).
After the print with stinky ABS or whatever is finished I would like to ventilate the enclosure at full speed. I am trying to add a command M106 P0 S255 to the end of gcode but whichever fan number parameter I use (P0 or P1 or P2 or P3) they always turn on the print cooling fan. Is there a way to send this command to thermo-coupled fan?
Thank you.