Hi there. I'd appreciate any help I can get as, right now I am at a loss.
Vellemann K8200 Repetier firmware on a RADDS shield with the RADDS LCD controller installed.
I had an Arduino Due clone board working with Repetier. For some reason during a print the clone board fried the CPU... No idea why!
I checked the power rails from the RADDS board to the Arduino at the pins and I was getting the voltages expected in the right places (3.3V and 5V). I thought maybe a component on the RADDS had gone wrong, but it appears not.
I bought an original Arduino Due and uploaded the working firmware from the previous board.
The upload completed with no problems. My Due now has the Green (ON) LED lit and the Orange (L) LED lit when connected to my macbook via USB post successful upload (not connected to RADDS)
If I connect to RADDS the firmware doesn't run. The LCD display shows two horizontal bars and does nothing else. When I reset the arduino with the reset buttons on it and on the RADDS board the printer jolts as it did before, but repetier sees the board when a connection is opened but states "Unknown Firmware waiting for temp"
Am I missing something here? The Repetier firmware I have uploaded was a working configuration and It has not been changed, so it should just work when uploaded to the new controller right?
Can anyone help me please![:)]( ":)")
Thank you in advance.
Thom
Vellemann K8200 Repetier firmware on a RADDS shield with the RADDS LCD controller installed.
I had an Arduino Due clone board working with Repetier. For some reason during a print the clone board fried the CPU... No idea why!
I checked the power rails from the RADDS board to the Arduino at the pins and I was getting the voltages expected in the right places (3.3V and 5V). I thought maybe a component on the RADDS had gone wrong, but it appears not.
I bought an original Arduino Due and uploaded the working firmware from the previous board.
The upload completed with no problems. My Due now has the Green (ON) LED lit and the Orange (L) LED lit when connected to my macbook via USB post successful upload (not connected to RADDS)
If I connect to RADDS the firmware doesn't run. The LCD display shows two horizontal bars and does nothing else. When I reset the arduino with the reset buttons on it and on the RADDS board the printer jolts as it did before, but repetier sees the board when a connection is opened but states "Unknown Firmware waiting for temp"
Am I missing something here? The Repetier firmware I have uploaded was a working configuration and It has not been changed, so it should just work when uploaded to the new controller right?
Can anyone help me please
Thank you in advance.
Thom