Hi all ,
i would like to implement my second extruder to an indipendent x axis.
i've seen that it is possible to configure in repetier firmware config tool "dual x axis" and link it to the Extruder E2 .
but how i must (where ) configure the pin for step, dir and enable , and how to set up the rest .
there is a guide ??
i would like to implement my second extruder to an indipendent x axis.
i've seen that it is possible to configure in repetier firmware config tool "dual x axis" and link it to the Extruder E2 .
but how i must (where ) configure the pin for step, dir and enable , and how to set up the rest .
there is a guide ??