Hi,
I am using:
I am using:
- Repetier Firmware 1.0.3dev
- Repetier Server Pro 0.91.2
- Printer CR-10S with E3D Titan Aero
After a few hours of printing I get a heater decoupled notification and the printer stops.
Is there a way to find out (logs etc):
- How long it was printing before the message appeared?
- If it was the bed or hotend that decoupled (I think hotend as Repetier Server shows hotend as DEC). I have the ext temp sensor set to ATC Semitic 104GT-2 as required.
- What temperature was commanded and what actual temperature was?
- Any other useful information like if the temperature should have been rising and it wasn’t or vice versa.
- If I can restart the print from where it stopped.